Feb 16, 2026

Drone Issue - Irregular Flight Behaviour at Field Guide Points

Home
/
Blog
/
,
Troubleshooting & Known Issues

Irregular Flight Behaviour at Field Guide Points

Last Updated
February 11, 2026
AEDT
Initial Report Date
February 5, 2026
Current Status
Resolved
Affected Platform
XAG P150 With RevoCast

Issue Overview

Description of issues:

Multiple operators observed abnormal behaviour when the aircraft approached or exited the field guide point:

  • The aircraft would pause and hover at the guide point
  • Flight speed would intermittently decrease during operation, the aircraft would then accelerate again after a delay

Causes of issues (Preliminary Finding):

Initial investigation identified a conflict involving the aircraft firmware called Navigation Service.

Further analysis determined that:

  • A recent parameter changes within the cloud configuration file conflicted with the Navigation Service
  • The conflict disrupted route-planning execution
  • The aircraft temporarily halted or slowed while recalculating navigation paths

This resulted in hovering at guide points and speed fluctuations during spreading operations.

Possible Issues Videos:

P150 in TAS – 02.09

Instructions for Customer

If similar behavior is observed, please submit a support form immediately via link: https://www.xag-au.com/request-repair-service

Then upload:

  1. Flight logs from the time period of the affected flight
  2. Upload app logs from the same date

Supply the following details in the form:

  • Aircraft serial number (SN)
  • XAG One App account ID
  • Date and time of logs uploaded

Solution

Date: 2026.02.11 Type: Permanent Status: Resolved

A corrected cloud configuration and Navigation Service update have been released.

Required Procedure:

  1. Connect the SRC4 remote controller to the internet
  2. Ensure the SRC4 is properly bound to the aircraft
  3. Power off the aircraft for 5 minutes
  4. Power on aircraft
  5. Repeat the power-off/power-on process twice: This forces the aircraft to refresh and download the updated cloud configuration
  6. After restart, update firmware while SRC4 is connected to the internet:
    1. Navigate to XAG One APP > Me > Device Page > P150 > Firmware Update
    2. Confirm Navigation Service is updated to Version 3.0.0.116
Text Link
Operation Guides
Text Link
Maintenance & Care
Text Link
Troubleshooting & Known Issues
Text Link
Software & Firmware Updates
Text Link
XAG News & Announcements